|
|
Post by wrighty on Aug 2, 2007 22:19:26 GMT 10
when installing the cams in a GZE the cam lobes for number one cylinder should be facing which way??? in or out??? any help would be appreciated.
Thanks Guys...
Wrighty.
(my GZE sprinter is on its way back to the streets)
|
|
|
|
Post by stuartgze on Feb 14, 2008 18:00:38 GMT 10
when installing the cam make sure the crank is line up at TDC you can check this by the notch in the crank pull for the timing belt. place the pullies on the front of both cams i hope you didn't mix them up. do the centre bolt up finger tight. line the timing marks up with the plastic cover they should be pointing verticley. place the caps on each one they are numbered so you don't mix them up. tighten them done evenly. they should be torqued up to about 16 - 18 NM  make sure you use assembley grease on the contact surfaces of the shafts and on the lobes. and poor a small amount of oil on the right had cam so you cover the buckets because it will take some time for oil to reach here when you first start the engine. the left side is ok because you fill the engine from here. the long bolts for the cover go the second one from the fron and the rear one you can check this with the cover. |
|
|
|
Post by wrighty on Feb 28, 2008 21:54:24 GMT 10
thanks dude, much appreciated
|
|
